Search results

Thank you, Sorry, I’m trying to figure it out. So the file type folder should be blank and the URL should be entered at Identifier right?

Thank you, sorry I’m a bit confused. Where do you add the streaming URL and How? Thank you

Hi Team, How’s it possible to add a Network Stream to a file type in order to use it for crossfade and Customize title. Thank you in advance

Thank you so much for your time My friend 🙏

Currently RB Audio output is to my Mixer ( Through Main DSP ) Mixer has Microphones fixed The Mixer output is connected to RB Input 1 Audio is fine as The Main DSP is attached. I don’t want to use the inbuilt microphone button in the radio boss. I want to off the Main DSP and Have The Mixer...

Oh Thanks a lot for the effort that you have taken to explain! So Is this for audio & mic both through the mixer? So Do I have to use the Mic button for this setup? Thanks a lot Dear Friend

Hi, Is there a Possibility to use Input Lines through DSP plugins for Input 1 or 2? Cause when The Mix comes through a mixer. The audio is fine as it do come through the main DSP but when it comes to the Microphone, There is No DSP for it to sound better as The DSP supports only the inbuilt Mic...

Sure, either manually or automatically would be OK. Because when the probability is set to 100% and the general crossfade fade-in is set with a value, everything works fine. However, when the probability is set to a lower value, like 50% or 70%, the general fade-in is applied whenever there is...

Yes… it does exist even after removing the bed. I tried fade in & out at 0.6. Yet getting the click noise time to time.

New Feature Request ( Intro ) - Separate Fade in Timing Option for Intro Played tracks only For tracks that are played with an Intro only, a distinct fade-in timing option would be ideal. a folder's tracks are all subject to the same basic crossfade settings. The default values for crossfade...

Thank you… Yes it is at certain stages. More noticeable when the DSP is on. The sample attached is when switching on the Mic DSP on + Bed.

I see.

I’ve attached a Sample as well

Hi Team, When using the RB Inbuilt Mic, there is a Pop noise that appears when you turn it off and on with the DSP turned on. If possible, I believe the built-in microphone should be included in a future update. I tried increasing and decreasing the crossfade timing, but the same noise was...

New crossfading option: Mix Start determines where the following track is mixed in; mix start can be automatically detected Hello, Where could this option be available to enable? Thank you

Yes! It’s good 👍

Hey, It sounds good, I was listening to your station this morning. Cheers 👋

Hello, have u found a solution? The internet is fine with a minimum upload speed of 50mbps & paid server is fine too on my test trial, any update plz let us know, Thank you

Thank you I’ll check the server again & what’s the error 46 Device is busy? Thank you in advance