How do I setup Breakaway to process audio?

[Ron]

I am looking for a tutorial top setup Breakaway with radioboss so i can process audio.

 

[ncborges]

I am looking for a tutorial top setup Breakaway with radioboss so i can process audio.

@WBGS-Founder : Breakaway Broadcast Processor is NOT a DJSoft software and probably you'll not get support from guys here that are concerned about their softwares.

The easiest way to do this is:

- Open Control Panel
- Open Sounds and Audio Devices
- Choose the Audio page
- Select Sound playback Default device: "Breakaway Pipeline 1"

This way, all the sound in your computer will go to the Breakaway Pipeline *instead* of your sound card.

Finally, in the I/O Configuration in Breakaway Broadcast Processor, select Input: Breakaway Pipeline 1 and L/R Output: Your sound card.

If you want to use Breakaway Broadcast Processor for live processing (sound card in -> sound card out),
you can select your sound card as both the Input and L/R Output, but you must make sure that only Line Input is selected as your sound card active input -- NOT Stereo Mix, as this would cause a feedback loop.

Hope it helps you

 

[radium98]

agree with ncborges