Can't Use Mic While Line In Is Active

[NounosSon]

Hello
I found a bug in RadioBoss. When you have your Line In active in RadioBoss your mic will not work. Last night I was doing a mix show. I had the line in active so RadioBoss could capture the audio from Virtual DJ from my sound card. When I click the mic button to talk it said it was on but it was not working. After I finished my show I tried it again. The line in was not active and the mic worked fine.

 

[djsoft]

Many sound cards can't record from more than one source at a time, which means, if you have LineIn working, you can't use mic input at the same time. What sound card are you using?

 

[NounosSon]

My mic is a usb mic. It does not go through my sound card.

 

[djsoft]

Thanks for the information. This bug will be checked soon.

 

[djsoft]

Checked o this bug, and it wasn't confirmed on the latest version. Mic and Line.In work fine together.
What version of RadioBOSS are you using? And are there any error messages in the bottom right corner?

 

[Nelson]

I think this is a good place to report a failure in radio boss.
I have 2 plates is sound and use it for monitoring. but when I start boss radio with headphones off (the audio board to not haver autoamticante disables any connected device) main air output stops working.
ecriture forgiveness for mistakes, I use google translator because I speak only Spanish

 

[djsoft]

I don't think it's a RadioBOSS fault.
You shouldn't start program with devices turned off.

 

[Nelson]

Hi Dmitry, sorry I wanted to put him to stop working is the output pre-listen, not monitoring. looks to me that if I disconnect will appreciate that output prelisten should only affect the output but not to air. (which is another independent board is still working properly) on my radio headphones eventialmente disconnect the sound card and take it to Broadcasts from the street and do not leave anything plugged into that outlet reiniciarce in the audio program leaves out principal. the only way to fix it without reconnect the headset is to enter the sound settings and where pre-listen to says no device as headphones enchfar reset again. other programs such as Virtual DJ does not pass this, when I unplug the headphones output is canceled pre-listen, but the output Mainly still working properly. pinto is my view. regards

 

[NounosSon]

Hello
Sorry for the late reply. I am using RadioBoss 4.6.3.905. There are no error messages.

 

[djsoft]

Please post here a screenshot of Settings -> Line.in/Microphone section.

This could also be a driver conflict between those devices... I triple-checked this issue and Mic and Line.In work fine together without issues.