RadioBOSS DTMF setup problem

IgorPobi

New member
Hello !

I have big problem with correct setup detect DTMF tones.
I check DTMF tones in URL (Shoutcast streaming) and when detect DTMF, starting event with play SAME Shoutcast streaming. RadioBOSS make 2nd copy of same streaming and i lost +- 3 sec in position.
This is not good. How transfer existing streaming (set in input DTMP url checker) to player ? This will be better solutions.

Thanks
 
Currently that's not possible for technical reasons. DTMF checker works completely separate from playback, therefore "transferring" stream is not possible without serious architecture changes. You can lower network stream playback buffer size (Settings->Playback->Miscellaneous), it could help to minimize stream drift.
 
Ok thanks !

Now, I tested Line.IN DTMF checker. When detect, start event with Line.IN .... but .... event begin after DTMF detect (this is correct) and ends after another DTMF detect (this is correct but i hear this end dtmf tone from LINE.IN). How avoid this ?
 
Yes but with this options delayed begin DTMF detection ....

How correct use DTMF detector in RadioBOSS ?

I have streaming or line.in signal and i need played this source from (for example) (DTMFDetect1 point)+2 second to (DTMFDetect2 point)-2 second. Change buffers size etc is not good way and is not fixed.
(bitrate size streaming, buffering etc etc).....
 
Yes, this is how it's designed to work - it's not designed to hide DTMF tones from listeners. Mainly this is because of two reasons:
1. Listeners do not care about those tones.
2. Almost every big station who use DTMF, has those tones present in their stream - which means they do not care also.

For now I can't offer you any solution... How critical is this for you? I think it could be possible to change this behavior in the future.
 
Thanks !

This is middle critical .... In future will be good to add better control for this options ...
 
Back
Top