New 5.2.6.0 problem

[Chris Deacon]

Hi Dmitry

I ran into a couple of problems with the update:

1. Performing the update from directly in the program resulted in an error - couldnt install adscheduler because it was already in use.  To work around this, I had to uninstall the old program, then reinstall after a reboot of the PC (Win10). 

2.  VU meter no longer works!

 

[Chris Deacon]

VU meter works when visualisation is switched OFF !!!

 

[Chris Deacon]

Update.....turning off visualisation also turns off VU meter....but if you reboot RB after this the visualisation re-appears....go figure?  Seems to be a bug here?

 

[Chris Deacon]

I have now set "on air visualisation" to none, and the VU meter works OK, without visualisation in the waveform.  This is confusing...why is it necessary for this to be setup in two different places?

 

[djsoft]

1. Performing the update from directly in the program resulted in an error - couldnt install adscheduler because it was already in use.  To work around this, I had to uninstall the old program, then reinstall after a reboot of the PC (Win10). 

You shouldn't uninstall it for updating. Close RadioBOSS and all its components is enough.

I have now set "on air visualisation" to none, and the VU meter works OK, without visualisation in the waveform.  This is confusing...why is it necessary for this to be setup in two different places?

There are two option, one completely turns off level processing, and one changes the type of visualization (spectrum, waveform, none).

 

[madbeatz]

Install over previous edition worked fine for me. Also I have no issues with VU or visualization at the moment as both are working.